Liquitex Flow Aid 118ml

Dramatically increase the flow of your color/mediums while minimizing brush strokes.

What it does

• Breaks water tension to improve flow and lower viscosity
• Gives a smooth finish with less brush strokes due to reduced surface friction
• Increases transparency and makes color more absorbent and blendable

How to use it

• Fully intermixable with all Liquitex products
• First dilute your concentrated Flow Aid with water – 1 part Flow Aid to 20 parts water – distilled water will give the best results. Use 1 part Flow Aid to 10 parts water if you want a more concentrated effect
• Add up to 25% of diluted Flow Aid to your color/medium and stir slowly to avoid foaming. If it does foam, leave it to sit while the foam disappears
• If applying to an absorbent surface, your color/medium will sink in like a stain or dye; if using on a non-absorbent surface your color/medium will be more fluid and take longer to dry

How not to use it

• Do not use Flow Aid undiluted as it results in poor acrylic adhesion, cracking, tackiness and water sensitivity
• As this is an additive – with no acrylic binders – do not add more than 25% to your color/medium and do not mix with other additives. This can cause excessive shrinkage, cracking and the acrylic film to break down
• Do not shake or stir too vigorously as foam will form
• Don’t use for marbling as it breaks the surface tension of the water
• Do not use with any non-acrylic media